KTOG Forum - New Member with some questions.

Check Messages

	KTOG is supported by: 09/08/10 at 20:14:09 News: NEW KTOG FORUM! - THE GREAT OUTDOORS! - CLICK HERE!

KTOG Forum › KelTec Products › P-32
(Moderators: Forum Admin, yzguy, TxCajun, JFB)

‹ Previous topic | Next topic ›

Pages: 1

New Member with some questions. (Read 207 times)

NH_KT

YaBB Newbies

I Love YaBB 2!

Posts: 3

New Member with some questions.
07/27/10 at 17:54:51

Hi, new member. I've had a p32 for almost a year now. Shoots fine/reliably with most ammo I've tried (Federal Hydrashok, Win Silver Tip) only jamming up when I used some really old American Eagle Flat nose hollow points and some old CCI alloy case blazer. I love this little pistol.
Its serial #004x2 so I assume its an early one. ~~Is there anything I should be aware of concerning the 1st gen guns (assuming this is one)?~~
Are other colored frames available anymore? I'd love a gray and/or OD green one.
~~What can I do to tune it up?~~

Thanks
"EDIT"
Found the FAQ. It appears that I have a 2G gun. I'm going to read through the tuning tips thread. Still would like to find out about the frames...

IP Logged

houser52

Junior Member

I Love YaBB 2!

Posts: 90
Gender: male

Re: New Member with some questions.
Reply #1 - 07/27/10 at 19:04:20

Are you talking about the grip? If so it's an easy and quick way to change colors.

I ordered a new grip for my P3AT and installed it last week. Wasn't too hard and the frame fit like it should.
The new grip with the mag catch and hammer block installed plus shipping was $36. It took only a few days to get it too.

It took me about 20 minutes to swap out but now that I know how to do it, I could change it in a lot less time.

IP Logged

NH_KT YaBB Newbies I Love YaBB 2! Posts: 3	Re: New Member with some questions. Reply #2 - 07/28/10 at 19:46:17 Where did you order it from? Direct from KT? I didnt see them listed on their site.
Back to top	IP Logged

virtual-rjhauser Forum Moderator Posts: 13129 Gender:	Re: New Member with some questions. Reply #3 - 07/28/10 at 19:54:28 Quote from NH_KT on 07/28/10 at 19:46:17: Where did you order it from? Direct from KT? I didnt see them listed on their site. you have to call to order a grip. ask for one with the hammer block and internals installed.
Back to top	IP Logged

houser52 Junior Member I Love YaBB 2! Posts: 90 Gender:	Re: New Member with some questions. Reply #4 - 07/28/10 at 21:27:54 That is correct. I called KT directly to place the order. KT also told me that they only sell the grips with the hammer block and mag catch installed.
Back to top	IP Logged

DIAMOND Grand Poobah U.S. Constitution 2nd Ammendment Posts: 614 Gender:	Re: New Member with some questions. Reply #5 - 07/29/10 at 06:31:33 Welcome! Our very own Goldenloki www.goldenloki.com has a huge assortment of colors and designs that he applies using Duracoat. Check out his picture page. Lots of neat combinations.
Back to top	Click image to enlarge My life's goal: to raise my post count one thread at a time Kel-tec P-3AT Buck Vantage Select, Kershaw IP Logged

NH_KT YaBB Newbies I Love YaBB 2! Posts: 3	Re: New Member with some questions. Reply #6 - 07/29/10 at 15:37:11 Thanks all for the replies. I'll have to order up a couple frames. I saw GoldenLoki's stuff too, looks awesome, love the camo jobs, but I kind of dont want to be without my baby...
Back to top	IP Logged

Pages: 1

KTOG Forum › KelTec Products › P-32
(Moderators: Forum Admin, yzguy, TxCajun, JFB)

‹ Previous topic | Next topic ›